Remove a noise isolation under a transmission.
If available, dismantle the bottom protection under the transfer case.
Remove the rear of the exhaust system and, if necessary, the catalytic converters (for V10 TDI).
Remove the rear driveshaft.
Remove the front driveshaft mounting bolts from the front final drive and transfer case.
If present, remove damper A of the transfer case (bolts B) (pic. 3.95).
Before dismantling, mark the installation position of the damper to the transfer case. Inscription «Thor» should point up.
Install the stand for the engine and gearbox VAG 1383 / A with an emphasis for the gearbox 3282, an adjustment plate 3282/37 for the gearbox «0AD» and support elements as follows: Place adjusting plate 3282/37 on gearbox stop 3282 (Adjustment plate only fits in one position).
Orient the arms of the gearbox stop levers in accordance with the holes in the adjustment plate.
The symbols on the adjusting plate indicate the required support elements, the arrow indicates the direction of travel.
Install a stand for the engine and gearbox VAG 1383/A with an emphasis for the gearbox 3282 under the gearbox, align the adjustment plate parallel to the gearbox and support the gearbox (pic. 3.96).
Attach the gearbox to the gearbox support 3282 with bolt A.
Unbolt the gearbox bracket B from the body.
Then unscrew the gearbox bracket from the transfer case console.
Disconnect the front propeller shaft.
Remove the transfer case/gearbox side and bottom mounting bolts.
Disconnect plugs A and B from the transfer case motor (pic. 3.97).
Lower the engine with gearbox using the VAG 1383/A engine and gearbox stand by about 60 mm.
Fix the engine with gearbox to the body using the clamping device VW 785/1B as follows: apply multipurpose grease to the contact surface of the support plate VW 785/1B.
Install thrust washer 3062 on the pedestal. Small diameter 3062 points to the pedestal.
Between the gearbox and the thrust washer 3062, place a wooden spacer A (pic. 3.98).
Dismantle the upper connecting bolts of the transfer case / gearbox A (pic. 3.99).
Remove ventilation tube B from transfer case 1 and unclip it 2.
Press the transfer case away from the gearbox.
Lower the transfer box.
Visitor comments