Removing
Remove the upholstery on the driver's side.
Remove the plug from the brake light switch (pic. 6.59).
Remove the brake light switch by turning 45°to the left.
Removal and installation of the brake light switch must be carried out only with the pusher pressed, otherwise the brake light switch stopper may be damaged.
Installing and configuring the brake light switch
To ensure a secure fit, the brake light switch may only be installed once.
Completely remove the pusher before installation.
Insert the switch into the mounting hole, press the pedal and secure by turning to the right by 45° (pic. 6.60).
The brake pedal remains in the free position (not pressed).
Install the brake light switch plug.
Check the operation of the brake light.
After adjusting the brake light switch, check if the brake pedal rests against the end stop (free standing).
Establish facing on the party of the driver.
Visitor comments