Removal, installation, adjusting and checking the thermostat (VW Beetle)

Removal

Remove the right rear shield that directs warm air.

Release the thermostat from the bracket and remove it.

Installation

Connect the thermostat to the connecting rod, install and secure it to the bracket.

Install the guide shield.

Adjustment

Connect the thermostat to the connecting rod.



Loosen the thermostat bracket mounting nut.

Press the thermostat upwards so that the valve is set to the open position.

Move the thermostat bracket until the thermostat touches the holder with its upper stop.

Check the operation of the regulator by moving the thermostat in both directions.

Secure the thermostat to the bracket.

Examination

Remove the thermostat.

Place the thermostat in a bath of water and heat the water to 65-70°C.

The article is published on this resource VWmanual.ru



At this temperature, the minimum length of the thermostat "accordion" should be a=46 mm.