Instructions: Depending on the configuration, the installation location of the fluid level sensor in the windshield washer reservoir "G33" may differ slightly from that shown in the figure. However, dismantling is performed in the same way.
Switch off the ignition and all electrical consumers, remove the ignition key. Remove the front left wheel arch liner. Unlock and disconnect the plug connector "1" of the fluid level sensor in the windshield washer reservoir "G33". Remove the fluid level sensor in the windshield washer reservoir "G33" "2" from its rubber seal.
Installation is in the reverse order, taking into account the following: After installation is complete, remove air from the headlight cleaning system.
Visitor comments