Checking the position of the gear shift lever
Engage 1st gear.
Move the gear shift lever all the way to the left.
Release the lever, measuring the amount of its movement, which should be within 5-10 mm.
Adjusting the gear shift drive
Working from underneath the vehicle, loosen the gear shift rod fork.
Remove the gear shift knob and protective cover.
Remove the gearshift lever ball cap and align the alignment marks.
Install the VW 3014 adjustment template.
Pull the gearshift lever and drive slide forward as far as it will go and tighten the clamping sleeve.
Move the gear shift lever to the 3rd gear line and tighten the nut of the gear shift rod fork bolt, acting from underneath the vehicle.
Remove the adjustment template and check the amount of movement of the gearshift lever as described above. If it differs slightly from the nominal value, refine the adjustment by moving the cap of the spherical head of the gearshift lever in the oval slots for the mounting bolts.
Gear shift control mechanism details:
1 - gear shift lever;
2 — gear shift drive rod;
3 - transmission link brackets;
4 - connecting tee;
5 - spacer sleeve;
6 - push rod;
7 — gear selection rod;
8 - fork stems;
9 — fork stem leash;
10 — reverse gear fork rod;
11 — reverse intermediate gear drive lever;
12 — fork for shifting III and IV gears;
13 — fork for shifting 1st and 2nd gears;
14 - clamps.
[The information is posted on this resource www.vwmanual.ru]
Visitor comments