Remove the oil pan.
Loosen the pump housing mounting bolts. Lower the pump down until the shaft is free of teeth and remove the pump completely
Unscrew the fasteners of the vacuum pump and remove it upwards.
The pump is installed in the reverse order:
Install the vacuum pump and O-ring. Tighten the bolts to a torque of 25 Nm.
Insert the drive shaft of the oil pump from below from the drive side of the vacuum pump and install the pump housing into the engine crankcase without a gasket. Tighten the bolts to a torque of 20 Nm.
Reinstall the oil pan.
Fill the engine with the required amount of oil, after making sure that the drain plug is installed and securely tightened.
Visitor comments