Replacement
1. Apply the handbrake, then raise the front of the vehicle with a jack and place it on stands.
2. Unscrew and remove the nuts of the connector of the transverse stabilizer 7 from the bottom of the transverse rocker arm on both sides of the vehicle.
3. Place a jack under the sub frame and support it.
4. Loosen the bolt at the rear end of the sub frame. fixing the stabilizer to the body, loosen the front bolt and move the stabilizer so that there is a gap between it and the rubber cushion 5, which makes it possible to remove the stabilizer 4. Repeat the same on the other side of the car.
5. Lift up the stabilizer connectors and disconnect them from the stabilizer. Mark the location and installation direction of rubber washers 21 and washers 8 of the stabilizer connector. Take out the stabilizer.
Tires should be stored in a cool, dry place. Must not come into contact with greases and oils. In a garage or basement, tires should be stored lying down or hung from a hook.
Winter tires require special wheel rims. Replacing a set of tires for every season does not justify itself (unprofitable).
Visitor comments