If shifting becomes inaccurate, the shift shaft of the transmission should be adjusted. To do this, turn the locking bolt of the switching shaft.
Install the gearshift lever in "neutral".
Pull out the safety spring of the connecting rod near the shift shaft lever at the top, remove the rod.
At the front of the plastic head of the control rod, use a screwdriver to lift the small plastic clip.
Detach the rod from the spherical head of the selector shaft lever.
Raise the locknut cover and loosen the latter.
Turn the locking bolt back so that the safety clip does not deviate. When properly adjusted, the safety clip lifts out of its seat with a slight turn of the switch shaft.
Lock the locking bolt, put on the cover if necessary.
Don't forget the link rod safety spring when attaching the switch rods.
Visitor comments