Contents: Dismantling ↓ Installation ↓
(1) gas pedal.
(2) Push rod. Lubricate with universal oil.
(3) Stopper. Replace.
(4) bearing bolt.
(5) Accelerator. Lubricate with universal oil.
(6) bellows.
(7) tightening bolt. Adjust the throttle rod so that the fuel pump lever rests against the stop without tension.
(8) stopper.
(9) gas thrust.
(10) Rubber nozzle. Fasten to the fuel pump support
Dismantling
Place the car on jack stands.
Remove the insert stoppers from the fuel pump support.
Disconnect the gas rod from the pump.
Remove the spare wheel and remove the gas pedal cover.
On the accelerator, unscrew the throttle rod clamp screw.
On the bottom of the car, in the area of the sheet steel bath, use a socket wrench to unscrew the rod holder.
Remove the gas rod.
Installation
Secure the gas rod to the holder at the bottom of the car.
Screw the rod to the accelerator, install the gas pedal cover.
Route the rod to the fuel pump, clamp it and adjust it.
Visitor comments