Front suspension arm bushings — replacement (VW Lt 28)

This is a job that should be left to a professional as the bushing retaining collars are welded in place and removing the bushings requires grinding down the collars. To remove and install the bushings you will need a press, and once finished you will have to weld the cuffs back on.

Figure 11.18. Welding spots of the suspension arm bushing cuff (Section 10).

(View the original on this portal: www.VWMANUAL.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Upper and lower front suspension pivot mounts (LT 28, 31, 35) — removal and installation
Upper control arm of the front suspension (LT 28, 31, 35) — removal and installation
Front suspension spring and lower arm (LT 28, 31, 35) — removal and installation
Radial arm (LT 28, 31, 35) — removal and installation
Front stabilizer — removal and installation
Front wheel bearings — adjustment and replacement

Next articles
Hub carrier (LT 28, 31, 35) — removal and installation
Front axle design (LT 28, 31, 35) — removal and installation
Front spring (LT 40, 45) — removal and installation
Flexible bushings of the front suspension (LT 40, 45) — replacement
Hub carrier (LT 40, 45) — removal and installation
Main Pin Bushings (LT 40, 45) — replacement

Front suspension arm bushings — replacement (VW Lt 28)

Visitor comments