2. Disconnect the rear end of the radius arm from the suspension bow, noting the location of the spacers and washers.
3. Installation is carried out by performing the above steps in reverse order. Because the installation of the levers affects the steering angle (see section 30), their effective length should be adjusted by turning the fastening stud until the measurement "a" shown in Figure 11.12 is between 532 and 537 mm. Tighten the special nut when the specified measurement value is reached.
Figure 11.12. Radial arm installation diagram (Section 6). Measure the distance "a" from the inner edge of the bracket cutout to the edge of the curved part of the bracket (indicated by the arrow).
Visitor comments