2. If you have the equipment, proceed as follows after removing the hub carrier (see previous section).
3 Use a press to remove the upper and lower bushings from the hub carrier.
4. Install the new bushings so that they are positioned as shown in Figure 11.28.
Figure 11.28. Main pin bushing installation diagram. a = 33.0 mm.
Use a measuring device to determine correct installation.
5. Insert the reamer (tool #3043) into the lower bushing and expand both bushings simultaneously to the required size. Be careful not to expand in the wrong direction as the reamer has two different expansion cutters.
Figure 11.29. Expansion of the main pin bushings.
6. Clean off any sawdust and insert the spacer ring until it is flush.
The original text can be found on the portal: VWMANUAL
Visitor comments