Contents: Removal ↓ Installation ↓
Parking brake lever: 1 - lever; 2 - lock nut; 3 - adjusting nut; 4 - compensating bracket; 5 - support finger (lightly grease); 6 - cable
Removal
Remove the front seats.
Remove the rubber sealing cuff of the parking brake lever and the rear floor covering.
Loosen the lock nut and adjusting nut of the brake cable and remove the compensating bracket, while holding the threaded part of the cable with a screwdriver.
The original information is posted on the resource [VWManual]
Remove the retaining ring from the parking brake lever support pin and remove the support pin.
Pull the parking brake lever (without pressing the shutter button) back until it is removed together with the toothed sector.
Press the shutter button (the toothed sector will separate).
Installation
Install the toothed sector into the parking brake lever so that its cutout fits onto the bearing sleeve of the support pin, and the toothed sector coincides with the pawl.
Install the lever from above into the mount in the frame channel. In this case, lay both ends of the cable on the left and right along the eccentric. Caution! When installing the lever, the toothed sector must be positioned so that its front cutout is on the edge of the metal sheet of the frame channel.
Lubricate the support pin and all hinges with general-purpose grease. Install the support pin and put on the retaining ring.
Secure the brake cable to the compensating bracket and adjust the parking brake.
Visitor comments