Contents: Removal ↓ Installation ↓
Removal
Disconnect the ground cable from the battery.
Disconnect the electrical wire from the automatic engine starting system.
Unscrew the 3 screws on the cover. Pull out the cover with the insert.
Installation
Insert the insert. The slot should be facing up and the frame should snap into place.
Insert the cover with the spring and heating coil. Mark the connection of the spring with the leash lever.
Install the cover, tighten 3 screws. Insert the cover with the spring so that the mark on the cover matches the mark on the carburetor body. Tighten the cover screws.
Connect the electrical wire to the automatic engine starting system, connect the ground wire to the battery.
Visitor comments