Disassembling and assembling the reverse gear shaft (VW Lt 2d)

The reverse gear shaft is shown in the figure 5.73.

Figure 5.73. Reverse gear shaft: 1 - Gearbox housing; 2 - Mounting pin; 3 - Retaining ring; 4 - Thrust washer; 5 - Reverse gear; 6 - Needle bearing; 7 - Reverse gear shaft; 8 - Bolts; 9 - Clutch housing.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Disassembly and assembly of the intermediate shaft
Disassembly and assembly of gearbox shafts
Gear shift forks
Disassembly and assembly of the gearbox, mechanism and gear shift forks
Gearbox housing, secondary and intermediate shafts, gear shift forks
Clutch housing, input shaft and gear shift mechanism

Next articles
Power take-off box
Removal and installation a manual transmission with a power take-off (PTO)
Flange, drive shafts and PTO engagement mechanism
Removal and installation the power take-off (PTO) valve
Wheel bearing runout adjustment

Similar articles from other manuals for VW cars:
Disassembling and assembling the water pump Passat B4 (1988-1996)
Disassembling and assembling the starter Golf 3 (1991-1997)
Disassembling the cardan shaft Polo 4 (2001-2009)
Letter designations, gear ratios, filling capacities (main… Touareg 1 (2002-2006)
Disassembling the engine Tiguan 1 (2007-2015)
Disassembling and assembling the starter Sharan 1 (1995-2000)
Disassembling the cardan shaft, replacing the protective casing… Transporter T3 (1979-1992)

Disassembling and assembling the reverse gear shaft (VW Lt 2d)

Visitor comments