Intake manifold (VW Lt 2d)

The intake manifold is shown in the figure 2.75.

Figure 2.75. Intake manifold: 1 - Throttle control unit; 2, 5 - Bolts; 3 - Throttle control unit connector; 4 - Intermediate flange; 6 - Bracket: 7 - Tension spring; 8 - Intake manifold; 9 - Filler plug; 10 - Adapter: 11 - Sealing ring; 12, 14 - Support brackets; 13 - Gasket.

(View the original on this portal: «www.vwmanual.ru»)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Adaptation of the engine control unit to the immobilizer control unit
Connecting the VAG 1598 tester
Block of measured values
Diagnostics of actuators
Interrogation and clearing of fault memory
Connecting the VAG 1551 fault code reader and selecting the «Engine electronics» function

Next articles
Fuel distributor
Checking the oxygen sensor heater
Checking the coolant temperature sensor
Checking the inlet air temperature sensor
Checking the supply voltage for the engine control unit
Checking injectors

Similar articles from other manuals for VW cars:
Checking the intake manifold heating system Passat B3 (1988-1993)
Overload cut-off valve and intake manifold heater (1.8 models… Golf 2 (1984-1993, petrol)
Checking the intake manifold pressure sensor Polo 3 (1995-2003)
Removal and installation the intake manifold (diesel engine) Touareg 1 (2002-2006)
Checking the operation of the intake manifold flap Tiguan 1 (2007-2015)
Removal and installation the exhaust manifold Sharan 1 (1995-2000)
Checking and replacing the intake manifold heater Transporter T3 (1979-1992)

Intake manifold (VW Lt 2d)

Visitor comments