Gear shift mechanism (5 speeds) — removal, disassembly, assembly and installation (VW Lt 28)

All processes are very similar to those written off in Section 3. To note the differences in component designs, refer to Figure 6.35.

Figure 6.35. Gear shift mechanism (5 speeds.) (Section 10): 1 - Handle; 2 - Backstage; 3 - Fastening; 4 - Finger (1st gear/reverse gear lock); 5 - Through bolt; 6 - Spring; 7 - Bearing; 8 - Washer; 9 - Gear shift lever; 10 - Selector lever rod; 11 - Selector rod (part 16); 12 - Support pin; 13 - Front bracket; 14 - Gasket; 15 - Support bolt; 16 - Selector rod (part 11); 17 - Rubber mount; 18 - Rubber mount; 19 - Rear bracket; 20 - Bushing.

[The information is posted on this website: VWMANUAL]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Gear shift mechanism (5 speeds) — adjustment
Gearbox (4 speeds) — assembly
Input shaft (4 speeds) — disassembly and assembly
Main shaft (4 speeds) — disassembly and assembly
Gearbox (4 speeds) — disassembly into main components
Gearbox (4 speeds) — removal and installation

Next articles
Gearbox (5 speeds) — disassembly into main components
Main shaft (5 speeds) — disassembly and assembly
Input shaft (5 speeds) — disassembly and assembly
Gearbox (5 speeds) — assembly
Troubleshooting — gearbox
Clutch and Gearbox Specifications — models since 1982.

Gear shift mechanism (5 speeds) — removal, disassembly, assembly and installation (VW Lt 28)

Visitor comments