Removal and installation of the input shaft, output shaft, differential, gearshift mechanism and inclusion forks
List of assemblies and parts of the input shaft, output shaft, differential, gearshift mechanism and forks with installation notes for drawing VC4.038:
1. Differential.
2. Gearbox housing.
3. Oil drain plug: 25 Nm.
4. Shaft with flange and spring.
5. Cone head screw: 25 Nm.
6. Screw: 5 Nm + 90° (replaced by a new one).
7. Hex nut 23 Nm (replaced by a new one).
8. O-ring.
9. Axis.
10. Screw: 5 Nm + 90° (replaced by a new one).
11. Gear selection and engagement mechanism.
12. Screw: 5 Nm + 90° (replaced by a new one).
13. Switch for reversing lights: 20 Nm.
14. Seal.
15. Gearshift mechanism.
16. Primary and secondary shaft assembly with thrust bearings.
17. Reverse gear support.
18. Reverse gear.
19. Screw: 25 Nm + 90° (replaced by a new one).
20. Oil catcher.
21. Magnet.
22. Oil guide part.
Visitor comments