Disassembly and assembly of the hub with a sliding sleeve of the synchronizer of 3rd and 4th gears (VW Caddy 3)

Install the sliding sleeve onto the hub. In this case, the ends (A) of the hub and the recesses for the crackers (B) of the coupling must coincide.

The device of the hub with a sliding clutch of the synchronizer of 3rd and 4th gears (see figure VC4.059):
1. Springs.
2. Sliding clutch for engaging 3rd and 4th gears.
3. Synchronizer hub.
4. Rusks.

Place the crackers into the recesses (arrows). Position the springs at a 120° angle relative to each other. The bent end of the spring should be located in the lower recess of the cracker.

(The information is presented on the website VWManual)

The notch on the top side (arrow) should point towards 4th gear.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Dismantling and assembly of the primary shaft
Disassembly and assembly of the internal gear shift mechanism
Internal gear shift mechanism of a manual transmission
Gearbox assembly
Disassembling the gearbox
Removal and installation of the primary shaft, secondary shaft, differential

Next articles
Checking the synchronizer locking ring for wear
Determining the thickness of the thrust ring
Disassembling and assembling the hub with a sliding sleeve of the 5th gear synchronizer
Removal and installation the secondary shaft
Disassembly and assembly of the secondary shaft
Setting position of 3rd and 4th gears

Disassembly and assembly of the hub with a sliding sleeve of the synchronizer of 3rd and 4th gears (VW Caddy 3)

Visitor comments