Heater switches
Use switches 1, 5 and key 6 to select the temperature, direction of air flow into the cabin and the volume of air supplied to the cabin.
Keys 2 and 4 are used to control various functions. Switches and keys are illuminated by LED lights.
1 - temperature controller
This switch is used to set the desired temperature in the cabin.
The set temperature in the cabin cannot be lower than the outside air temperature. The greatest heating of the cabin and fast cleaning of the glass are possible only when the engine is warmed up.
2 - rear window heater
Approximately ten minutes after switching on, the rear window heating switches off automatically. You can switch off the heating earlier by pressing the button.
3 - heating switch
In cars with an independent heater, pressing this button heats the interior with this heater. To turn off the independent heater, press this button again.
4 - air recirculation mode in the cabin
When recirculation mode is turned on (the LED in the key is on) it is possible to avoid polluted air from entering the passenger compartment, for example, when driving in a tunnel or stuck in a traffic jam.
At low outside air temperatures, recirculation mode increases interior heating because the air from the interior is heated instead of the cold outside air.
5 - cabin air flow direction switch
This switch allows you to direct the air flow in the desired direction:
Visitor comments