Contents: Removal ↓ Installation ↓
Removal
1. Disconnect the electrical wires from the glow plugs.
2. Remove the glow plugs.
Installation
1. Screw in the glow plug and tighten it to a torque of 15 Nm.
2. Do not exceed the tightening torque of the glow plug, otherwise the annular gap between the working and threaded part of the glow plug will be reduced or completely closed. The normal value of the annular gap is 0.5 mm. A decrease in the annular gap leads to rapid failure of the glow plug (1 - glow plugs with a normal annular gap, 2 - without annular gap).
3. Connect the electrical wires to the glow plugs.
(The original article is available at: www.VWMANUAL.ru)
Visitor comments