Remove the safety grille.
Remove additional resistance.
Loosen the locking screw at the front of the fan; disconnect the wires.
Remove 4 screws from the fresh air box (see picture below). Press the box downwards.
View the original on the website: www.VWMANUAL.ru
Left: The fan switch component (1) is secured with a spring clip (2). The multi-pin connector (3) has already been removed.
On the right: the fan (5) with its additional resistors (6) is visible. On the left in the photo, one of the locking screws (4) of the heater housing is visible.
Remove the fan.
Since there is little space near the washer reservoir, the fan should be pulled out without turning or using force.
When installing, proceed in reverse order.
If too much force is applied during installation and removal, the fan wheel may become deformed; subsequently an unpleasant noise appears or the wheel touches the body.
Visitor comments