Removal and installation the central flap actuator motor (VW Tiguan 1)

Remove the front panel. Disconnect the connector on the central flap actuator motor "V70". Unscrew the mounting bolts "1" 1.4 Nm and remove the central flap actuator motor "V70".

Installation is carried out in reverse order.

Instructions: After installation, check the operation of the central flap. Using the tester -MS 5051B- (or the subsequent model) perform a basic installation.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Tarasov Ivan

Previous articles
Removal and installation the actuator motor of the right temperature control flap
Removal and installation the control mechanism of the supply ventilation flaps
Removal and installation of the actuator motor of the supply ventilation flaps
Removal the G107 and G134 light sensors
Removal the temperature sensor of the left and right deflectors
Removal and installation of the air pollution sensor (cars from calendar week 22/08)

Next articles
Fluids for air conditioning systems
Safety precautions when working with the Thermo Top V additional heater
Repair of additional heater Thermo Top V
Manufacturer's plates on the Thermo Top V heater
Removal and installation of the heater exhaust system
Removal and installation the heater radio signal receiving device

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet