Instruction: The rotary control unit consists of two separate parts. Before removing the unit, set the rotary controls to the following positions: heater control to position "cold", fan to position "0", airflow direction "to the feet".
Remove trim for heater and air conditioner control panel. Remove screws -2- (4,2x45) and -3- (4,2x16) and remove the control unit -1- from the center console.
Tightening torque for screws -2- and -3-: 1.5±0.2 Nm. Unclip connector lock -A- by sliding it in direction of -arrow 1-. Press lock on connector -B- in direction of -arrow 2- and remove connector -C-. Unclip connector -D- and remove connector -D-.
Visitor comments