Removal and installation the steering wheel button blocks
Removal and installation of the left and right button block are performed in a similar manner. Remove the airbag module from the steering wheel. Remove the driver's side airbag module. Disconnect connector "1".
Unscrew the "arrow" screw. Remove the key block.
Removal and installation the multifunction steering wheel control unit
Remove the airbag module from the steering wheel. Remove the airbag module from the driver's side. Disconnect both connectors from the control unit. Carefully pry and remove the control unit with a suitable "arrow" screwdriver.
Components of a system consisting of a transmitter/receiver, battery, fuse and wiring harness
- 1 - Positive terminal, red wire with corresponding terminal
- 2 - To terminal 15a, protect this wire with a fuse, fuse protection max 15 A
- 3 - Antenna weight, it is necessary to ensure good contact with the body, the antenna installation location must have appropriate anti-corrosion protection
- 4 - Transmitting and receiving antenna
- 5 - Shielded antenna cable, cable with coaxial connector
- 6 - Telephone or radio receiving and transmitting device
- 7 - Wiring harness, positive power supply wire red, cross-section 2.5 mm², negative power supply wire brown, cross-section 2.5 mm². If necessary, a black wire with a cross-section of 1.5 mm² is laid to terminal 15a
- 8 - Fuse block, installed in close proximity to the battery
- 9 - To the starter
- 10 - Battery
- 11 - Negative wire
- 12 - Mass on the body
Visitor comments