- 1 - Outer CV joint, replaced only as an assembly, installation: put on the shaft until it stops with blows of a plastic hammer
- 2 - Bolt, 70 Nm and tighten by 90°, replace after each removal, when loosening and tightening the bolts, the car must not stand on wheels
- 3 - Retaining ring, replace after each removal, install in the groove of the shaft
- 4 - Thrust washer
- 5 - Elastic washer
- 6 - Clamp, replace after each removal
- 7 - CV joint boot, check for cracks and abrasion
- 8 - Clamp, replace after each removal
- 9 - Drive shaft
- 10 - Clamp, replace after each removal
- 11 - Boot of a ball inner CV joint, without a vent hole, check for cracks and abrasion
- 12 - Retaining ring, replace after each removal, install in the groove of the shaft
- 13 - Clamp, replace after each removal
- 14 - Ball inner CV joint, replaced only as an assembly, installation: put on the shaft until it stops with blows of a plastic hammer
- 15 - Protective cap
Visitor comments