- 1 - Outer CV joint, replaceable only as an assembly, installation: press onto shaft with blows of a plastic hammer until it hits the groove of the spring retaining ring
- 2 - Bolt, 70 Nm and tighten by 90°, replace after each removal, when loosening and tightening the bolts the car should not stand on the wheels
- 3 - Retaining ring, replace after each removal, install in the shaft groove
- 4 - Clamp, replace after each removal
- 5 - CV joint boot, check for cracks and wear
- 6 - Clamp, replace after each removal
- 7 - Drive shaft
- 8 - Clamp, replace after each removal
- 9 - Tripod joint boot, check for cracks and wear
- 10 - Clamp, replace after each removal
- 11 - Tripod with rollers, the chamfer of the splined hole "arrow" should be facing the splined end of the drive shaft
- 12 - Retaining ring, replace after each removal, install in shaft groove
- 13 - Adapter
- 14 - Hinge housing
- 15 - Protective cap
Visitor comments