List of components and parts of the drive shaft (CV joint VL100) with technological notes on repair to drawing VC4.124:
1. CV joint outer:
- is replaced only in the collection;
- press on the shaft until it stops with a plastic hammer.
2. Hub screw:
- when unscrewing and tightening the bolts, the car must not stand on wheels;
- Replace after each removal.
3. Drive shaft:
- for installation on the right side.
4. Collar:
- replace after each removal;
- crimp.
5. Boot outer CV joint:
- check for cracks and abrasion;
- material: Hytrel (polyelastomer).
6. Collar:
- Replace after each removal.
7. Elastic washer:
- mounting position.
8. Thrust washer:
- mounting position.
9. Retaining ring:
- replace after each removal;
- install in the groove of the shaft.
10. Boot inner CV joint:
- material: Hytrel (polyelasgomer);
- without ventilation hole;
- check for cracks and abrasion;
- remove from the hinge with a drift;
- before installing on the CV joint, apply D454300A2 to the seating surface.
11. Collar:
- Replace after each removal.
12. Drive shaft:
- for installation on the left side.
13. Backing plate.
14. Bolt with an internal polyhedron:
- after each removal, the bolts must be replaced.
15. Retaining ring:
- replace after each removal;
- Using circlip pliers, install into the groove of the shaft.
16. Seal:
- the surface of the CV joint, to which the seal is glued, must be degreased!
17. Inner CV joint:
- is replaced only in the collection;
- examination.
18. Spring washer:
- mounting position.
Visitor comments