Insert the outer CV joint into the splined hole in the wheel hub.
Pull the steering knuckle out and insert the drive shaft into the wheel hub.
Attention: Do not damage or crush the boot.
Screw ball joint mounted on steering knuckle to triangular link -arrows-.
Install the inner CV joint of the drive shaft on the gearbox flange and tighten its fastening bolts crosswise to a torque of 5 Nm.
Tighten the fastening bolts crosswise to the prescribed torque.
Install the lower soundproof casing.
Install the wheel and tighten the wheel bolts.
Tighten the hub bolt.
Carefully! The vehicle must not be on wheels.
Once the bolt is loosened, the wheel bearing may be damaged by the weight of the vehicle.
Visitor comments