Installing the valve cover (VW Caddy 3)

If there is any damage, replace the cylinder head cover seal and screw seal.

Apply sealant to both joints of the support cover and the cylinder head at the front (diameter: approx mm) (arrows).

Apply sealant to both joints of the support cover and the cylinder head at the front (diameter:…

Apply sealant to the back in a similar manner (diameter: about S mm) (arrows).

Install the cover and secure it with screws, tightening them in the sequence shown in the figure. Tightening torque: 10 Nm.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Checking the cylinder head for warpage
List of parts and assemblies of the cylinder head
Cylinder head for diesel engines 1.9 and 2.0 l BDJ, BST, BJB, BSU, BLS
Cylinder head gasket markings
Measuring the protrusion of pistons from the cylinder block at TDC
Mounting position and alignment of pistons to cylinders

Next articles
Removal and installation the cylinder head
Camshaft, valves and pump-injector drive
List of components and parts of the valve mechanism
Checking the axial run-out of the camshaft
Valve sizes
Removal and installation the camshaft

Installing the valve cover (VW Caddy 3)

Visitor comments