Contents: Removal ↓ Installation ↓
1 - bumper cover
2 - guide piece
3 - 8 screws
4 — mounting plate
5 - 7 screws
6 - protective pad
Mounts in the bumper casing.
7 - 8 self-locking nuts
Removal
Note: The bumper consists of a casing and a bumper beam.
[The original material is available on the portal: vwmanual.ru]
Open the back door.
Remove the taillights.
Remove screws "3" and "5".
Together with an assistant, pull the bumper cover on the right and left in a horizontal plane backwards from the guide parts "2" and the mounting pad "4".
Disconnect the license plate light connector and remove the bumper cover.
Unscrew 3 nuts on the right and left respectively and remove the bumper beam.
Installation
Screw the bumper beam. Tighten the 3 nuts on the right and left to a torque of 20 Nm.
With the help of an assistant, insert the bumper cover into the guides and onto the mounting plate. Make sure that the bumper cover enters the guides evenly and does not warp. Secure the bumper cover with screws.
Connect the license plate light plug connector.
Install tail lights.
Visitor comments