Removing
Turn off the ignition and turn off the lamp through the switch.
With the ignition off, disconnect the ground wire from the battery (-).
Attention: Follow the instructions given in chapter «Removing and installing the battery».
Open the tailgate and fold the trim in the area of the rear light to one side.
Unplug and disconnect the plug connector on the back of the lamp.
Loosen the wing nut in the recess.
Push the rear light up and pull out the retaining hooks -arrows-.
Installation
Installation is carried out in reverse order.
Replacing an incandescent lamp
Remove rear light and unplug connector -2- at rear of light -1-.
Press locking tabs -arrows- and detach bulb holder from lamp.
1 - rear light housing
2 - turn signal lamp
3 - brake signal lamp
4 — a lamp of a headlight of a backing
5 - side light lamp
6 - lamp position light and rear fog light
7 - lamp holder
8 - seal
Push incandescent bulb into holder, turn counterclockwise and remove.
Insert a new lamp into the holder, turn it clockwise and fix it.
Check the operation of the flashlight with a new incandescent lamp.
Visitor comments