Contents: Removal ↓ Installation ↓
Removal
Turn off the ignition and turn off the headlight using the switch.
With the ignition off, disconnect the ground (-) cable from the battery.
Attention: Follow the instructions given in the chapter "Removal and installation the battery".
Note: When installed, it is impossible to determine on which side of the turn signal lamp the support point "1" is located, and on which the plastic spring "2" is located. Therefore, if possible, do not press the lamp with a screwdriver. If you try to press the lamp from the spring side, you can damage the lamp and/or the paintwork.
Press the turn signal lamp with a plastic wedge, for example, HAZET 1965-20, in the direction of the arrow and press the lamp away from the wing at the support point "1". In this case, the lamp, overcoming the force of the plastic spring "2", moves forward.
Remove the socket with the incandescent bulb from the flashlight housing.
Remove the incandescent lamp from the socket.
Installation
Insert the incandescent lamp into the socket and insert the socket with the lamp into the housing.
(The original article is posted on the website: VWManual)
Hook the lantern with support point "1" onto the edge of the hole in the wing, and on the other side press the lantern to the wing and fix it.
Check the operation of the flashlight with a new bulb.
Visitor comments