Removing
Turn off the ignition and turn off the headlight using the switch.
With the ignition off, disconnect the ground wire from the battery (-).
Attention: Follow the instructions given in chapter «Removing and installing the battery».
Pull the locking hooks -arrows- forward and unhook. Unfasten the air grille in the bumper cover.
Remove 3 screws -arrows-, pull fog lamp forwards out of bumper cover and unplug electrical connector.
Installation
Installation is carried out in reverse order. At the same time ensure the correct position of the air grille and the fixing hooks.
Check the headlight adjustment at the service station and, if necessary, adjust the headlights.
Replacing an incandescent lamp
Remove fog lamp.
Release the wire clip on the back of the fog lamp and remove the cover.
Disconnect plug -1- from bulb.
To unlock the wire clamp -2-, press the locking tabs -3-.
Open the wire clamp and remove the incandescent lamp from the reflector.
Insert a new incandescent bulb so that the notch of the bulb holder rests on the guide lug of the housing.
Further installation is carried out in the reverse order.
Check headlight operation with a new bulb.
Visitor comments