With the ignition off, disconnect the ground (-) cable from the battery.
Attention: Follow the instructions given in the chapter "Removal and installation the battery".
Note: After installation, check the operation of the lamp with a new bulb.
Front ceiling light
Removal
Press cover "1" of the interior control system away from the ceiling trim. To do this, insert a plastic wedge, for example, HAZET 1965-20, under the cover from behind and press it down. 2 — two rear locking springs.
Pull the cover back a little, slide the wedge along the side of the cover and release the left locking spring "3".
Press the cover to the right and release the right locking spring.
Remove the cover from the ceiling trim and disconnect the plug connector from the back of it.
Using a plastic wedge, slide along the ceiling light "1" from the side and unfasten the rear locking hooks "2" on the left and right.
Pull the ceiling light back slightly and release the front locking hook.
Remove the lampshade from the ceiling trim and disconnect the plug connector from the back of it.
Central ceiling lamp: Using a plastic wedge, carefully push the diffuser out of the ceiling lamp, remove the spotlight from the holder and replace it with a new one.
Side reading light: turn the "arrow" socket on the back of the ceiling light counterclockwise and remove it from the light together with the incandescent bulb. Remove the defective bulb "1" from the socket and insert a new one in its place.
Installation
Installation is carried out in reverse order.
Folding mirror light/trunk compartment light
Removal
Folding mirror light located in the roof trim: Fold the sun visor forward.
Press the flashlight using a flat-head screwdriver.
Remove the spotlight from the holder.
Installation
Insert a new spotlight into the holder, insert the flashlight from the side of the plug connector and secure it.
Rear ceiling light
Removal
Use a flat-head screwdriver to pry the light away from the headliner.
Unfasten and remove the diffuser of the lampshade "1" at the front and rear of the locking hooks "arrows".
Remove the spotlight from the holder and replace it with a new one.
Installation
Installation is carried out in reverse order.
Visitor comments