2. Click «08» to select a function «Reading a block of measured values» and confirm by pressing the button «Q». The display should show the following information:
3. Select the desired group press «004» for selection «Display group» and confirm pressed buttons «Q». The display should show the following information:
4. Observe the 8-digit block of numbers in zone 4 of the display (the right four digits don't matter).
5 Operating mode display:
- Idling: the second digit from the left should be 1-01000000;
- Partial throttling (rpm increase gradually): the third digit from the left must be 1-00100000;
- Full throttle (throttle valve fully open): the fourth digit from the left must be 1-00010000;
- Mode of exceeding the permissible speed (speed above 3000 rpm, suddenly close the throttle): all the time when the speed is above 1200 rpm, the first digit from the left should be 1-11000000 (briefly).
6. Next click «→».
7 Press «06» to select a function «Output Completion» and confirm by pressing the button «Q».
8. If the specification values are not reached, interrogate the fault memory, correct the faults and clear the fault codes from the memory.
Visitor comments