Instructions: The front support panel is a part, the condition of which determines the safety of the vehicle. For this reason, it cannot be repaired. If damaged, it must be replaced.
Bring the front panel and the parts "1" installed on it to the service position. Disconnect the electrical connectors. Drain the coolant and disconnect the cooling system hoses. Disconnect the pipes from the condenser. With the help of a second mechanic, unscrew the guide rods -T 10093- from the left and right side members and remove the front support panel.
CAUTION: Do not start the engine if the air conditioning and/or cooling system lines are disconnected! Do not allow the condenser and oil cooler to hang on the lines. Do not bend the condenser and oil cooler lines.
Installation is carried out in the reverse order. It is necessary to ensure that the electrical connectors and hoses are connected correctly during assembly. Brackets must be installed on the side members. The tightening torques of the threaded connections are indicated in the diagram. Center the position of the front bearing panel on the side members relative to the wings.
Bumper brackets
- 1 - Bracket, left and right
- 2 - Bolt, 2 per side, 55 Nm
The original material is available on the portal: VWMANUAL.ru
Visitor comments