Contents: Removal ↓ Installation ↓
The Perrot brake caliper for LT 46 vehicles is shown in the picture 8.18.
Figure 8.18. Perrot brake caliper for LT 46 vehicles: 1 - Lid; 2 - Air bleed valve; 3 - Seal; 4 - Protective cover; 5 - Piston; 6 - Brake caliper; 7 - Bolt; 8 - Brake lining wear indicator wire; 9 - Brake pipe.
Removal
1. Press the piston out of the brake caliper (figure 8.19).
Figure 8.19. Press the piston out of the brake caliper.
2. Remove the sealing ring using feeler gauge 3409 (figure 8.20).
Figure 8.20. Remove the sealing ring using feeler gauge 3409.
Installation
3. Lubricate the piston and sealing ring with paste G 052 150 A2 before installation.
4. Install the sealing ring into the brake caliper.
5. Install the protective cover with the outer sealing edge on the 1st piston (figure 8.15).
6. Insert the inner sealing lip into the cylinder groove using feeler gauge 3409 (figure 8.21).
Figure 8.21. Insert the inner sealing lip into the cylinder groove using feeler gauge 3409.
7. Press the piston into the brake caliper (figure 8.22).
Figure 8.22. Press the piston into the brake caliper.
The text is copied from this portal: VWMANUAL.ru
Visitor comments