2. Press "08" to select the "Read measured value block" function and confirm by pressing the "O" button. The display should show the following information:
3. Select the desired group. Press "04" to select "Display Group 4" and confirm with "Q". The display should show the following information:
4. Observe the 8-digit block of numbers in area 4 of the display.
5. Display in working mode:
- idle: The second digit from the left should be 1-01000000;
- partial throttling (the revs increase gradually): the third digit from the left should be 1-00100000;
- full throttle (throttle valve is fully open): the fourth digit from the left should be 1-00010000.
Overshoot mode permissible rotational speed (Overrun) (speed is above 3000 rpm, suddenly close the throttle valve): all the time when the speed is above 1500 rpm, the first digit on the left should be 1-1100000 (short-term).
6. Next, click "→".
7. Press "06" to select the "Complete Output" function and confirm by pressing the "Q" button.
8. If the specification values are not achieved, interrogate the fault memory, correct the faults and clear the fault codes from the memory, check the throttle potentiometer and idle switch.
Visitor comments