Reading the measured value block and basic settings (VW Polo 3)

The measured values in the functions for reading the measured value block and the basic settings are described during the individual test.

Changing display groups is performed in the following sequence:

Display group	V.A.G 1551	V.A.G 1552
Tall	Press 3	Press ↑
Low	Press 1	Press ↓

The original article is available at (www.VWManual.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Clearing fault memory
Querying fault memory
Connecting the VAG 1551 fault code reader
Self-diagnosis of the injection system
Mono-Motronic fuel injection and ignition control system
Exhaust gas system

Next articles
Checking the oxygen sensor and lambda control
Checking the Oxygen Sensor Heater
Checking the engine operating modes
Checking the coolant temperature sensor
Checking the injector
Checking the inlet air temperature sensor

Similar articles from other manuals for VW cars:
Basic information about engines Passat B3 (1988-1993)
Basic tools and equipment Golf 1 (1974-1984, petrol)
Removal and installation a compressor without a solenoid valve… Touareg 1 (2002-2006)
Removal and installation the turbocharger vacuum block Tiguan 1 (2007-2015)
Cylinder Block — Check Sharan 1 (1995-2000)
Basic parameters for adjusting the chassis Transporter T4 (1990-2003)
Reading a block of measured values LT 2D (1996-2003)

Reading the measured value block and basic settings (VW Polo 3)

Visitor comments