Clamps for fastening additional wires
When working on the electrical system, to prevent the risk of short circuits in the electrical wiring, always disconnect and set aside the battery ground (-) cable.
Caution! If the battery has been disconnected, engine, gearbox, and anti-lock braking system faults are erased from the control unit's memory, and other electrical devices, such as the radio and clock, are switched off or their memory is erased.
When drilling holes in the body, the edges must be deburred and coated with primer and varnish. Shavings must be carefully removed.
If required (to avoid noise while driving) from newly laid cable, as well as its abrasion, protect it additionally with insulating tape, plastic mass, cable clamps, etc. In this case, pay special attention to the fact that there is a distance of at least 10 mm between the brake pipes and laid cables, and a distance of at least 25 mm between the brake pipes and cables that move together with the engine or other parts of the machine.
When installing additional electrical consumers, it is necessary to check each time whether the generator can withstand the load from the installed devices. If necessary, provide for the installation of a more powerful generator.
Visitor comments