Inlet pipe of carburetor 2E3 and 2E4 (VW Transporter T3)

Removing the intake pipe, see section on carburetor 34 PICT.

Removing the intake manifold heater, see section on carburetor 34 PICT.

Checking the intake manifold heater, see section on carburetor 34 PICT.

Note: Secure all hoses with clamps so that the clamps can be removed without removing the engine. Replace gaskets.

The text has been checked: Tarasov Ivan

Previous articles
Checking the idle air cut-off valve
Pulldown device check
Checking and adjusting the injection quantity of the accelerator pump
Checking and adjusting the air damper gap size
Checking and adjusting the idle speed of a cold engine
Partial Load Channel Heating Test

Next articles
Basic data of carburetor 2E3 and 2E4
Checking the thermostat housing and vacuum membrane