Removing
Mark the running direction of the V-ribbed belt.
Using a suitable wrench, push the tension lever in the direction of the arrow (pic. 2.4).
Screw the bolt M8x50 into the threaded hole A, thus fixing the tension roller of the V-ribbed belt.
NOTE: Only screw in the bolt just enough to remove the V-ribbed belt, otherwise the tensioner housing may be damaged.
Remove poly V-belt.
Installation
Before installing the V-ribbed belt, check that all units are securely fastened (generator, air conditioning compressor, vane pump).
Check the ease of rotation of the take-off roller.
When installing the V-ribbed belt, observe the correct direction of travel and the correct position of the belt on the pulleys.
Lay the V-ribbed belt and unscrew the M8 bolt from the tension roller.
Start the engine and check the belt (pic. 2.5).
Visitor comments