Generator — wiring connection options (VW Lt 28)

18. The generator connector located at the rear of the generator can be held in place in one of two ways shown in Figures 13.62 and 13.63.

Figure 13.62. Generator connector with flat clamp (section 13A): 1 - Connector; 2 - Flat clamp.

Figure 13.63. Generator connector with wire clamp (section 13A): 3 - Connector; 4 - Wire clamp.

The original information is posted on the resource [VWmanual.ru]

19. If a connector with a flat clamp is being replaced with a connector that is to be secured with a wire clamp, the center partition on the clamp must be filed down so that the flat clamp can fit into place.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Kolesnikov Artem

Previous articles
Generator — overhaul (models with 2.4l engine)
Generator — removal and installation (models with a 2.4 l engine)
General Information — battery (1982 and later models)
Starter motor — overhaul
Starter motor — removal and installation
Starter Motor — description and testing on a vehicle

Next articles

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Caddy 3 Beetle LT 2D LT 28