Attention!
- Welding or straightening of load-bearing or guiding suspension elements is not allowed.
- Corroded bolts or screws and nuts must be replaced.
Removing
The steering column is supplied only as an assembly, its repair is not provided for by the design.
1. Set the car wheels straight.
2. Move the steering column adjustment lever to the down position.
3. Lower and pull out the steering column as far as possible.
4. Set the steering column adjustment lever to its original position by turning it up.
5. Remove the driver's airbag.
6. Remove the steering wheel.
7. Remove facing of understeering switches, a ware compartment from outside the driver and a understeering switch.
3. Unscrew the mass cable (1) from the steering column.
9. Disconnect the cable channel (2).
10. Open the locks (arrows) and remove the footwell trim.
11. Remove the bolt (1) and remove the universal joint (2) from the steering shaft.
12. Remove the bolt (arrow) fuse block mounting.
13. Remove the bolts (1).
14. Movement upwards carefully take a steering column.
Installation
Installation of a steering column is made upside-down. After installing the steering column, the basic setting of the steering angle sender G85 must be checked.
Visitor comments