Contents: Dismantling ↓ Installation ↓
(1) Windscreen wiper motor
(2) Windscreen wiper frame and rods
(3) brush
(4) brush holder
(5) automation relay
(6) lubricate with molybdenum grease
(7) rubber
(8) adjust the deviation
Dismantling
Disconnect the battery from ground.
Remove the windshield wiper blades, see above.
Remove the cover from the axles, unscrew the nuts.
Open the glove box and remove the box from its hinges.
Remove the control panel, see above.
Remove the plug from the windshield wiper motor.
From inside the car, unscrew the 4 countersunk head screws near the windshield.
Pull the frame and wiper rods towards the seat next to the driver.
If necessary, unscrew the engine from the frame.
Installation
Bolt the wiper motor to the frame.
(92-307) connect the engine to the on-board network, let it run for a few minutes, then turn it off. In this position, set the crank 1 and rod 2 in the direction of the line in the figure, and then secure the crank 1 on the engine shaft.
Insert the wiper blade into the seat next to the driver.
Place washers on the axles, then pull them through the holes in the body.
Install a rubber gasket, washer and nut on the outside.
From the inside, secure the frame in the windshield area using 4 screws.
Carefully tighten the nuts on the wiper shafts to a torque of 8 Nm.
Put the caps on the nuts, mount the brush holders, see above.
Connect the plug to the engine.
Install the glove box and hang 2 loops.
Install the remote control, see above.
Connect the battery to ground.
Visitor comments