Contents: Dismantling ↓ Installation ↓
Dismantling
Disconnect the battery from ground.
Remove the control panel, see above.
remove the ashtray from the control panel upwards:
(90-308) remove the antenna plug (arrow).
remove the left headlight, see above.
(90-309) unscrew the union nut.
(90-310) carefully pull the antenna downwards, without bending the antenna feeder.
Installation
(90-331) form a loop, then insert the antenna.
Place the plastic part on the antenna, screw in the antenna, straighten and tighten.
Run the feeder to the radio receiver.
Attention! Do not lay the feeder near the windshield wiper, heating and ventilation rods.
Insert the antenna plug into the radio receiver.
Install the headlight, see, above.
Install the ashtray.
Install the remote control, see above.
Connect the battery to ground.
Match the receiver to the antenna. To do this, tune it to a weak medium-wave radio station and set the antenna tuning screw (in front on the scale) for the best reception.
Visitor comments