Removing
NOTE: It is not necessary to remove the steering wheel. However, for clarity, the steering wheel is not shown in the following figures. Place the steering column with electric or mechanical adjustment in the lowest position and pull it towards you until it stops. Switch off the ignition and all electrical consumers, remove the ignition key.
Pry up and remove panels 1 and 2 with wedge T10039/1 from the clips (pic. 7.69).
Unscrew the screws 1 of the upper facing panel of the steering column 2 and remove the panel (pic. 7.70).
Remove the instrument cluster visor.
Unscrew the screws 1 of the holder of the visor of the instrument cluster 2 (pic. 7.71).
Remove bolts 1 (pic. 7.72).
Remove the instrument cluster visor holder by pulling it up.
Remove the dash panel insert and unplug connectors 1 on the back of the dash panel insert (pic. 7.73).
Installation
Installation is carried out in the reverse order, paying attention to the following.
Install the instrument cluster into the socket on the front panel and connect the connectors.
Establish the holder of a peak of a combination of devices.
After installation, check the operation of the functions of the instrument cluster.
Description of the rear side of the instrument cluster
NOTE: Do not disassemble the instrument cluster. If necessary, the instrument cluster is replaced as an assembly.
Visitor comments