Operating instructions — switches (VW Lt 2d)

Rear window heating

The heating only works when the engine is running. When the heating is on, the indicator light on the switch comes on.

Please note: The rear window heating will automatically switch off after approximately 15 minutes.

Heated seats

The heating works only when the ignition is on. You can choose between two heating levels. The selected level is shown accordingly by a separate indicator.

• Low heat: Press the switch on top - the top indicator lights up.
• High heat: Press the switch below - the lower indicator lights up.
• To turn off the heating: set the switch to the middle position - to do this, press either the top or bottom.

Differential lock

When the differential lock is engaged, a warning light on the instrument panel comes on.

To turn on, press the switch at the top; to turn off, press the switch at the bottom.

The differential lock must not be engaged when driving on a hard road surface while the wheel is spinning, for example because the vehicle is stuck in snow, when towing a disabled vehicle, or on a roller test stand, for example when checking the brakes.

Power take-off box with power take-off from the gearbox

The information is posted on this website (www.VWmanual.ru)



The power take-off box allows the operation of additional consumers with power take-off from the vehicle's gearbox. Depending on the type of operation, its duration or transmitted power must be limited.

Attention! Additional power take-off is engaged only when the gearbox is in neutral position.

On vehicles with a shift lock, the manual transmission is locked when the auxiliary power take-off is engaged. On vehicles without a shift lock, additional power take-off can be used with the vehicle stationary or with the vehicle moving in first or second gear.

When the power take-off is engaged, a warning light on the instrument panel comes on.

With the vehicle stationary and the engine running: press the clutch pedal several times, wait 3-6 seconds and then engage or disengage the power take-off. Release the clutch pedal.

Adjusting the rotation speed of the power take-off flange

1 - idle speed; 2 - Maximum rotation speed.

The rotation speed of the connecting flange on the power take-off box is adjusted by a lever under the instrument panel. To decrease the rotation speed, move the lever forward; to increase it, move it backward.

Turn signal switch

Headlight switch

Turn light switch 3 to the desired position:

Parking lights. The parking lights come on only when the ignition is off. The right parking lights come on when the right turn signal is activated, the left ones come on when the left turn signal is activated.

Turned off.

Parking light ¹⁾.

Low or high beam headlights.

¹⁾If, on vehicles for some export countries, the parking light is switched on when the ignition is switched on, the low beam headlights also come on at reduced brightness.

Rear fog light

The low beam or high beam headlights must be on.

Front fog lights/rear fog light



The low beam or high beam headlights must be on.

To turn on the front fog lights, press the switch at the top - the indicator light in the switch comes on; to turn on the rear fog light, press the switch at the bottom. To turn off, set the switch to the middle position - to do this, press the switch from the top or bottom.

Headlight range control

The regulator allows you to adjust the angle of the headlights depending on how loaded the vehicle is. The headlights can only be adjusted when the engine is running.

Emergency light signaling system

The system also operates when the ignition is off. When the hazard warning lights are on, all direction indicators on the vehicle flash simultaneously. In this case, the turn signal light and the indicator light on the switch flash simultaneously.