Adjusting the fuel pump EPVE 6/10 F 2150 L 324
(DV engine 75 kW)
Charging pressure: 750 hPa
| Basic adjustment | Rotation speed (rpm) | Values |
| Advance device stroke | 1500 | 2.2 - 2.6 mm |
| Feed pump pressure | 1500 | 0.60 - 0.66 MPa |
| Total load without recharge pressure | 600 | 24.5 - 25.5 cm³/1000 strokes |
| Total load with recharge pressure | 1850 | 34-Z5 cm3/1000 moves |
| Idle speed limitation | 375 | 6 - 10 cm³/1000 strokes |
| Max limit. speed | 2400 | 13 - 17 cm³/1000 strokes |
| Starting overload | 100 | min. 35 cm³/1000 strokes |
Injection advance regulator
| Rotation speed (rpm) | Increase in savings (mm) |
| 1250 | 0,5 - 1,3 |
| 1500 | 2,2 - 2,6 |
| 1850 | 3,7 - 4,5 |
| 2150 | 3,7 - 4,5 |
Supply pressure
| Rotation speed (rpm) | Feed pump pressure (MPa) |
| 600 | 0,36 - 0,42 |
| 1500 | 0,60 - 0,65 |
| 2150 | 0,77 - 0,83 |
Overflow valve overflow rate
| Rotation speed (rpm) | Consumption (cm³/10 sec) |
| 600 | 41 - 83 |
| 2150 | 55 - 133 |
Final adjustment
| Area of work | Rotation speed (rpm) | Consumption (cm³/1000 strokes) | Recharging pressure (hPa) |
| Maximum | 750 | 31 - 32 | 300 |
| 2575 | 0 - 6 | 750 | |
| 2400 | 13 - 17 | 750 | |
| 2350 | 15,5 - 25,5 | 750 | |
| 2150 | 30 - 32 | 750 | |
| 1850 | 34 - 35 | 750 | |
| 1250 | 38 - 42 | 750 | |
| 750 | 31 - 32 | 300 | |
| 600 | 34,5 - 38,5 | 750 | |
| 600 | 24,5 - 25,5 | — | |
| Stop | 375 | 0 - 3 | — |
| Idling | 375 | 6 - 10 | — |
| 500 | 0 - 4 | — | |
| End of cutoff | 250 | min. 35 | — |
| 450 | max. 40 | — |
Visitor comments